The Process                                         

Step 1                                                                                  

The ground is marked with spray paint or a string line. A small sod cutter is used to remove the grass around the existing beds. This will not disturb existing beds. The ground is leveled and tamped before the curbing is extruded.

Step 2                                                                                   

The concrete is mixed onsite using a small mixer and trailer. There is no heavy equipment or concrete trucks on your yard..

Step 3

The concrete is dumped into wheel barrows and taken and shoveled into the curbing machine. It is extruded from the curbing machine as a continuous piece of concrete curbing.

Step 4

The curb is then smooth finished with a hand trowel. It can also be topped with a colored slurry mixture and

textured with our special stamping tools if desired.

Step 5

Control/Expansion joints are cut every 3-4 feet while the concrete is still wet. The cuts are approximately 40% into the curb.